Unboxing Videos of Pekoko & set up of Pekoko,easy to operate compared with XDR and Mbrush

1.Install the ink cartridge to the ink cartridge pull ring. 1) Remove the ink cartridge and peel off the nozzle seal film from the ink cartridge. 2) Install the pull ring to the cartridge. NOTE: When replacing a new ink cartridge, remove the tab and install it on the new ink cartridge. 2.Load the cartridge and the pull ring into the printer. 1) Put the ink cartridge (with the pull ring) in the printer body with the nozzle facing down, and press the ink cartridge 2) After pressing, the cartridge is pressed by the stainless steel shrapnel without shaking, indicating that it is installed in place. 3.Install the battery into the printer 1) Insert the two card slots on the front of the battery into the corresponding grooves on the main body, and push the battery from the back to the front to ensure that the cards fully enter the grooves. Note: The insertion angle should not be too large, try to be parallel to the printing product, otherwise the battery position may be broken. 2) Press the spring button on the back of the ink cartridge, and press the battery downwards at the same time, let the two card slots on the back of the battery slide into the corresponding grooves smoothly, then release the spring button to complete the battery installation. Note: Be sure to ensure that the metal contact probe in front of the battery is clean, free of debris and short-circuited, ensure that it is dry, cannot contact water and other liquids, and can bounce normally without scratching or bending. 4.Power on and start printing 1) Press and hold the boot button on the bottom for 5 seconds, the device will boot. 2) Wait until the light turns blue, indicating that the device is powered on normally and the ink cartridge installation is recognized correctly. 3) According to the prompts on the fuselage, hold the entire device with the logo in front. 4) Click the print button on the top, and move the device from left to right until hear 2 consecutive beeps, indicating that the information printing is complete. 5) Repeat steps 1-4 to print this information repeatedly. Note: For the first printing, the printing result may not be good because the ink cartridge is not working for a long time and the temperature is not enough. If the moving speed is too fast (higher than 10cm / second), it may cause the print content to become disconnected. 5.Device goes into standby and wakes up 1) If the device is left for 20 seconds without operation, it will enter the standby state and flash the breathing light 2) Click the print button on the top to wake up the device. The blue light indicates that the device has been woken up. 3) Device can only receive files transmitted by APP when it is awake. 4) During the file transfer, the device flashes red. Restore blue light after reception is complete. 5) If the device is not used for more than 5 minutes, it is recommended to cover the nozzle protection cover. For details, refer to section 3.6. 6) Long press the power button for 5 seconds to turn off the device. 7) If not in use for a long time, it is recommended to turn off the machine and remove the battery. 6.Use of nozzle protection cover and scraper The nozzle of the ink cartridge is easy to be damaged. If it is not used for a long time, it should be protected with cover. 1) There are 2 protruding small circles on the left and right sides of the protective cover for easy removal of the protective cover. 2) The U-shaped rubber plastic sheet protruding from the rear of the protective cover is a wiper blade for cleaning the nozzle of the ink cartridge. When other dust accumulates in the ink cartridge near the nozzle, or the print has blank line, need to clean the nozzle. 3) clean the entire nozzle surface with the wiper from top to bottom. 4) If the wiper effect is not obvious, can clean the nozzle surface from top to bottom with a dust-free cloth or clean tissue.